Steps followed during mother board installation?

1. Gather all necessary tools and components for the installation, including the motherboard, CPU, RAM, graphics card, power supply, and any other necessary components.

2. Prepare the case by removing the side panels and any existing components that may be in the way of the motherboard installation.

3. Install the CPU onto the motherboard by lifting the CPU socket lever, aligning the CPU with the socket, and gently lowering the lever to secure the CPU in place.

4. Install the RAM modules onto the motherboard by opening the RAM slots, aligning the notches on the RAM module with the notches on the slot, and firmly pressing down until the clips on the slot snap into place.

5. Install the motherboard into the case by aligning the screw holes on the motherboard with the standoffs in the case, and securing the motherboard in place with screws.

6. Connect the power supply to the motherboard by plugging in the main 24-pin power connector and the 4 or 8-pin CPU power connector.

7. Install the graphics card into the appropriate PCIe slot on the motherboard, securing it in place with screws if necessary.

8. Connect any additional components, such as storage drives, fans, and front panel connectors, to the motherboard.

9. Double-check all connections and components to ensure everything is properly installed and secured.

10. Replace the side panels on the case and connect the power cable to the power supply.

11. Power on the computer and check for any error messages or issues during the boot process.

12. Install the operating system and any necessary drivers and software to complete the setup of the computer.

Steps for Motherboard Installation:

1. Prepare the Computer Case:

- Open the computer case by removing the side panels.
- Locate the motherboard mounting holes in the case.

2. Align the Motherboard:

- Take the motherboard out of its anti-static bag and carefully align it with the mounting holes in the case.
- Ensure that the I/O panel at the back of the motherboard matches the openings in the case.

3. Install Standoffs:

- Place metal standoffs (usually included with the motherboard) into the mounting holes in the case.
- These standoffs create a buffer between the motherboard and the case, preventing short circuits.

4. Secure the Motherboard:

- Secure the motherboard to the case by screwing it into the standoffs.
- Do not overtighten the screws.

5. Install the Processor:

- Open the socket lever on the motherboard and carefully align the processor with its designated socket.
- Gently insert the processor into the socket and close the lever.

6. Install CPU Cooler:

- Apply thermal paste to the top of the processor.
- Mount the CPU cooler onto the motherboard and secure it according to the manufacturer's instructions.

7. Install Memory (RAM):

- Open the clips on the memory slots and slide the RAM modules into place.
- Ensure that they are properly seated and the clips engage.

8. Install Storage Devices:

- Connect the SATA or NVMe storage devices to the appropriate connectors on the motherboard.
- Secure them with screws or clips.

9. Install PCIe Cards:

- Locate the PCIe slots on the motherboard and align the expansion cards you wish to install.
- Press them down firmly until they lock into place.

10. Connect Power Supply:

- Plug the 24-pin motherboard power connector and the 8-pin CPU power connector into the corresponding sockets on the motherboard.
- Ensure that the connections are secure.

11. Connect Case Connectors:

- Locate the case header pins on the motherboard and connect the front panel buttons, LEDs, and USB ports.

12. Power On and Test:

- Close the computer case and connect the power cord.
- Press the power button to start the system.
- Verify that the components are properly functioning.