Procedure followed when doing wheel alignment after repair of steering system? ?

1. Inspect the steering system: Before performing a wheel alignment, it is important to inspect the steering system to ensure that all components are in good working condition. This includes checking for any loose or damaged parts, such as tie rods, ball joints, and steering linkage.

2. Adjust the toe angle: The first step in wheel alignment is adjusting the toe angle, which is the angle at which the wheels point in relation to each other. This is done by adjusting the tie rods to ensure that the wheels are parallel to each other.

3. Adjust the camber angle: The next step is to adjust the camber angle, which is the angle at which the wheels tilt in relation to the vertical axis. This is done by adjusting the upper or lower control arms to ensure that the wheels are perpendicular to the ground.

4. Adjust the caster angle: The final step in wheel alignment is adjusting the caster angle, which is the angle at which the steering axis tilts in relation to the vertical axis. This is done by adjusting the upper or lower control arms to ensure that the wheels are properly aligned with the steering axis.

5. Test drive: Once the wheel alignment has been completed, it is important to test drive the vehicle to ensure that it is driving straight and handling properly. If any issues are detected, adjustments may need to be made to the alignment.

6. Final inspection: After the test drive, a final inspection should be conducted to ensure that all components are properly aligned and functioning correctly. This includes checking for any signs of uneven tire wear or steering issues.

7. Provide customer with alignment report: Finally, provide the customer with a detailed alignment report that outlines the adjustments made and any recommendations for future maintenance. This will help the customer understand the work that was done and ensure that their vehicle is properly aligned.

Procedure for Wheel Alignment After Steering System Repair

1. Safety Precautions:

- Park the vehicle on a level surface and engage the parking brake.
- Allow the vehicle to cool down if necessary.
- Wear appropriate safety gear (eyewear, gloves).

2. Preparation:

- Gather necessary tools and equipment (alignment rack, bubble level, torque wrench).
- Clean all steering and suspension components.
- Remove any obstacles that may interfere with alignment (e.g., debris, loose wires).

3. Inspect and Adjust Steering Components:

- Check for proper installation and tightening of all steering components, including:
- Steering rack
- Tie rods
- Ball joints
- Wheel bearings
- Adjust components as necessary to ensure proper operation.

4. Set the Vehicle on the Alignment Rack:

- Position the vehicle on the alignment rack and secure it with the wheel clamps.
- Level the vehicle using the bubble level on the rack.

5. Mount the Alignment Targets:

- Place alignment targets (e.g., magnetic or reflective strips) on all four wheels.
- Ensure the targets are correctly positioned and secured.

6. Align the Front Wheels:

- Use the alignment equipment to measure and adjust the following front wheel alignment parameters:
- Camber
- Caster
- Toe-in
- Refer to the vehicle manufacturer's specifications for acceptable alignment values.

7. Align the Rear Wheels:

- Measure and adjust the rear wheel alignment parameters:
- Camber
- Toe-in
- Ensure the rear wheels are aligned parallel to each other and the front wheels.

8. Adjust Steering Wheel Angle:

- If necessary, adjust the steering wheel angle to ensure it is centered when the vehicle is driving straight.

9. Lock Down the Adjustments:

- Tighten all bolts and nuts to the specified torque values.
- Remove the alignment targets.

10. Road Test:

- Perform a road test to verify the alignment adjustments.
- Check for any abnormal handling or tire wear.

11. Documentation:

- Record the alignment readings and any adjustments made.
- Provide the alignment report to the customer.